Why do pipes burst when they freeze?
Water expands as it turns to ice, and the expansion can split a pipe even though the ice is still inside it. The break frequently happens downstream of the frozen section, where pressure builds.
When a pipe freezes, the ice blocks flow. Water behind the blockage keeps its pressure, and the wall of the pipe can crack at a weak point. The split may not show until the ice melts and the water starts flowing through the new opening.
Pipes that run along exterior walls, through unheated crawlspaces or beside a garage door are the most exposed. Insulation helps, and so does keeping the house heated to a steady level, but a single cold night in an uninsulated corner can be enough.
What should I do if I think a pipe has frozen?
Open the cabinet doors, let warm air reach the pipe and turn on a faucet so water can flow once the ice begins to melt. Shut the main if water starts coming through the ceiling or the wall.
Gentle warmth is safer than an open flame. A space heater placed well away from anything that can burn, or warm air from a hair dryer on a low setting, can thaw a pipe. Never use an open flame or a heat gun near plastic pipe or insulation.
If water appears, find the main valve and close it at once. Then call Fort Wayne Water Damage Restoration at (833) 490-5225, since a burst pipe can release a large volume in minutes and the water should be removed before it reaches finished rooms.
Why does drying take longer after a burst pipe?
The water often travels into wall and floor cavities that cannot be seen, and insulation holds it. Each of those cavities has to be opened and dried to readings before the repair can close the wall.
Clean water from a supply line is less hazardous than sewage or river water, but it still soaks into wood and drywall. A single fitting can spray water into a joist bay or onto the subfloor under several rooms, and those areas need checking.
Insulation that has absorbed water usually comes out, because it holds moisture for a long time and can keep framing wet. Framing and subfloor are dried in place when the readings allow, and the crew logs each reading so the drying end point is clear.
Does a freeze always mean the pipe needs replacing?
Not always. A pipe that froze without splitting may need only thawing and a check for leaks, while a split section usually needs cutting out and replacing by a plumber.
A plumber inspects the whole run after a freeze, because a pipe can be cracked without leaking until pressure builds. Testing the line before closing the wall prevents a second visit and a second round of damage.
The crew does not repair plumbing, but it notes which section split and where the water traveled, so the plumber knows where to start. The homeowner should share that record and the drying log with the repair contractor.
How can a household lower the risk next winter?
Insulate exposed pipes, seal gaps where cold air enters the crawlspace or wall, and keep a steady heat setting during cold weather. Know where the main shutoff is before the next freeze.
Pipe sleeves and foam insulation are inexpensive protection for exposed runs. Heat tape can help along the most exposed sections, though it should be installed and used according to the manufacturer's directions. Keeping cabinet doors open under sinks on exterior walls lets warm air reach the pipes.
A household that leaves for a trip should keep the heat above a safe floor and ask someone to check the house during a long freeze. A simple written plan for shutting off the water can save a room and a great deal of drying time.