River Flood Damage
Water from the St. Joseph, St. Marys or Maumee is pumped out, the silt is cleared and the framing is dried before rebuilding.
Fort Wayne Water Damage Restoration takes calls for the water damage services listed here, from river flood damage and basement flooding to sewer backup cleanup, frozen and burst pipes and mold after water. Pick the service closest to what you see, or describe the loss on the phone and the right crew is matched to it.
Fastest: call (833) 490-5225. Or send this and we call you back.
The services below follow the causes that show up most in Fort Wayne: rivers that rise after heavy rain, basements that take water through a floor drain or a window well, sewers that back up when a storm overwhelms them, and pipes that freeze in a cold winter and show damage later.
Each service page explains what the crew does first, what it removes and what it dries in place. Water from a river or a sewer is treated as the more contaminated category and changes the work, so the call starts by asking where the water came from.
Water from the St. Joseph, St. Marys or Maumee is pumped out, the silt is cleared and the framing is dried before rebuilding.
Water that enters a basement is pumped out, the walls are checked and the space is dried before finish work restarts.
Sewage that comes up through drains is removed, the affected rooms are sanitized and every wet material is dried or replaced.
A pump that stopped during a storm leaves the pit overflowing, so the water is removed, the pit is cleaned and the basement is dried.
A pipe that froze and split is isolated, the spilled water is removed and the walls and floors behind it are dried.
Snowmelt and rain on frozen ground push water toward the foundation, and the water is removed and dried once it gets inside.
Rain that forces its way through windows, doors, vents and window wells is removed, traced to its entry and dried.
Water from a roof leak is traced through the attic and ceiling, the wet material is removed and the framing is dried before repair.
Standing water is pumped and extracted from floors, carpets and crawlspaces before anything else is done.
Air movers and dehumidifiers pull moisture from the framing, subfloor and wall cavities until readings reach their dry targets.
Mold that follows a water event is contained, the wettest materials are removed and the structure is dried before cleaning.
Water that fills a crawlspace is pumped out, and the joists, insulation and subfloor above it are dried to readings.
A stained or sagging ceiling is opened, the wet insulation and framing above it are dried and the source is found.
A leaking water heater is isolated, its spilled water is removed and the floor, wall base and nearby framing are dried.
Water from a washer, dishwasher or refrigerator is removed, and the cabinet base, subfloor and flooring are dried.
A failed supply line or an overflowing toilet is shut off, its water is removed and the floor, wall and subfloor are dried.
Water in an office, shop or restaurant is removed after hours where possible, dried in phases and documented for the business and its insurer.
Wet carpet, pad, hardwood, tile and subfloor are assessed separately, dried on their own timelines and replaced only where the readings require.
| Service | Typical range | Details |
|---|
Estimates only. Your price is confirmed on site before work starts. See the full price guide.
Call any hour and explain what is going on. You get a clear price before any work starts.
Not as a separate booking. The call sorts the loss into the right first steps, and the crew uses the water category to plan removal, cleaning and drying for the job as a whole.
Frozen and burst pipes and crawlspace water damage are the two to read. The crew checks the crawlspace for moisture even when the leak was in a line that runs through a wall above it.
Yes. Downtown offices and shops are served, and the drying plan is built so the space can reopen as soon as the readings allow it.
Standing water comes out first when it is present, and drying follows. Some losses have no standing water and go straight to moisture readings and drying.